Unboxing Italeri’s 1:24th Land Rover Fire Truck


From the blog at the Spinneyworld shop.

You wait for years for a 1:24th scale Land Rover kit to be released or reissued, then two come along at once. Well, almost at once. The Italeri model is out now, with a Revell kit expected in September.

I’ll be buying both, and measuring them up for components and add ons. I’ve already done a roof rack for Italeri’s 1:35th kit, I ought to do one for its big brother.

The Italeri arrived today, and I did a quick unboxing and took some photos. Check out the gallery embedded below, or click through to Flickr.

Italeri 1:24 Land Rover Fire Truck

Sorry for the blur in some of the photos. I thought I’d try out the SLR, rather than use the phone camera. It was surprisingly dark, and it had issues focusing on the sprues.

The model is curbside (surely hedgeside, as it’s an offroader), so there’s no engine detail. It can be built left or right hand drive, and, unlike the 35th scale version, remembers to tell you which side to put the breather vent. There’s no obvious flash, and few sink holes or ejector marks. There are a couple of moulding tabs on the front of the roof that will need removing, but they’re the largest issues.

Sprue D is made up of Fire Truck parts. If I do build the kit, I’ll probably be ignoring it, and using the bits I design and get printed. But if you are going to use it, it contains a lot of neat bits. The water pump in particular is nicely detailed.

I’ll be doing a comparison of this kit to the Revell one when it arrives. In the mean time, I’m going to design some add on bits.